NEWARE battery tester software glossary-Battery test

HOME Glossary Software

Glossary

Hardware Module

Product Features

Product Parameters

Min Vi

The present step will be cut off when the minimum voltage of the auxiliary channel is less than or equal to the set value.
Max Ti

The present step will be cut off when the maximum temperature of the auxiliary channel is greater than or equal to the set value.
Min Ti

The step will be cut off when the minimum temperature of the present step auxiliary channel is less than or equal to the set value.
Capacity

It represents the electricity of a battery: the amount of charge stored inside the battery when it is charged under the current of 1A for 1h.
Cycle layer

Summary data of cycle, including cycle number, charge capacity, discharge capacity, efficiency, etc.
Cycle life

The cycle number before the battery capacity is reduced to a certain value under specific charge/discharge conditions
Plateau voltage

In constant current charge/discharge process, there exists astage where the voltage changes slowly/has a steady process, the corresponding voltage value is called voltage plateau.
Discharge time

The consumed time for a Battery to discharge to the termination voltage.
Capacitance value

The amount of the electric charge stored in a capacitor at a specific electric potential.
Priority mapping

The unassigned auxiliary channels are assigned to the selected main channel in priority.
Reset mapping

Rearrange the channels and display them on the software interface.
Super mapping

The channels of multiple control units are mapped to the same interface.
Jump

Terminate the present step and jump to the selected step.
Move

Move the unfinished test to another channel.
Single start

Manually start the selected channel.
Cycle

Make the step run repeatedly between the selected steps.
Loop start

Restart the test with the steps of the last test, and combine the data of the two tests together.
Single stop

Manually stop the selected channel.
All start

Load the barcode file and start all the channels under one control unit or in one cabinet.
Layer start

Under the production line mode, start the all channels of one layer by pressing at one time.
All stop

Stop all channels under under one control unit or in one cabinet.
Preset pause

Set the pause condition in advance, and stop the test when the operation of the step meets the condition.
Set parallel

Set the selected channels in parallel mode.
Release parallel

Release parallelled channels.

NEWARE and Cookies

We use Cookie to personalize and improve your experience with our website. By continuing to browse the site you are agreeing to our use of cookies.