NEWARE Glossary-learning center for battery tester

HOME Glossary

Glossary

Hardware Module

Product Features

Product Parameters

Discharge

As the reverse prosscess of charge, the battery will convert storaged chemical energy into electric energy during the discharge.
Constant resistance discharge

Discharge with constant resistance.
Constant current discharge

Discharge with a constant current.
Constant voltage discharge

Discharge with a constant voltage.
C-rate

The current value for a battery to deliver rated capacity at certain duration, it equals to the ratio of current/nominal capacity.
Cut-off condition

Cut-off conditions of the running work steps.
Cut-off C-rate

Take C-rate as the Cut-off condition for the work steps.
Cut-off voltage

Take the Voltage as the Cut-off condition in the work steps.
Cut-off current

Take the Current as the Cut-off condition in the work steps.
Charge

A energy storage prosscess that the battery convert electric energy into chemical energy.
Rest

A state that the battery on channel is neither charged nor discharged.
Resume

The been interrupted battery returns the state when it was stopped/protected/paused, and continues the next test.
Stop

Manually pause the current test and can be resumed.
Pause

A presetted step used to pause the current test and can be resumed.
Finish

The corresponding state of the channel after finishing the presetted all steps.
Off-Line

Disconnected with tester or control unit and cannot be operated.
Constant current charge

Charge with a constant current.
Constant voltage charge

Charge with a constant voltage.
Constant current and constant voltage charge

Charge with constant current and constant voltage.
Constant current and constant voltage discharge

Discharge with constant current and constant voltage.
Pack constant current constant voltage

Charge with constant current and constant voltage on battery packs
Constant power charge

Charge with a constant power.
Direct Current Internal Resistance

Test the ratio of voltage change to current change of the battery under operating conditions.
Voltage vibration difference

If the ΔV between the voltage of the first data of the rest step and the last voltage of the previous step exceeds the set value, the channel will be protected.

NEWARE and Cookies

We use Cookie to personalize and improve your experience with our website. By continuing to browse the site you are agreeing to our use of cookies.